This solid carbide slotting endmill is used to cut slots for use with the 1/16" SmartVac 3 vacuum gasket. This special endmill also cuts a chamfer at the top of the groove. The smaller slot width puts just enough compression on the gasket to hold it snugly in place.
Groove depth should be cut to .045" - .050" deep.
Shank diameter is .125".
Chamfer is 45 deg.
Slot width is .059".
3 Flutes, High Helix
Recommended Feeds and Speeds:
Full Depth of cut
MAXIMUM coolant/air possible for chip evacuation.